Where is the petroleum refinery?
Select an option to see the answer and solution.
Automobile Engineering · all questionsAutomobile Engine
Automobile Engine
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
632
Questions
5/32
Page
Pick an option on a question to see the right answer and solution.
What is the advantages of LPG as a motor fuel?
Select an option to see the answer and solution.
The pressure in the vicinity of main jet of a carburettor remains
Select an option to see the answer and solution.
In compound wound starter motors the field coil is
Select an option to see the answer and solution.
If two meshing gears have 4 : 1 gear ratio and the smaller gear has 12 teeth, the large gear will have
Select an option to see the answer and solution.
The tilt of the front wheels from vertical, when viewed from the front, is called:
Select an option to see the answer and solution.
The thrust bearing should come into contact with the release levers when the
Select an option to see the answer and solution.
The compression ratio for a practical diesel engine usually lies in the range
Select an option to see the answer and solution.
Which of the following does not relate to a spark ignition engine?
Select an option to see the answer and solution.
Oil sump is the . . . . . . . . most part of engine.
Select an option to see the answer and solution.
The drive-shafts are connected to the differential and wheel hubs through universal joints because the universal joints
Select an option to see the answer and solution.
What is the lowest point of backward travel of piston in the cylinder?
Select an option to see the answer and solution.
The cross section of brake shoe is of:
Select an option to see the answer and solution.
An alternator frame is made of
Select an option to see the answer and solution.
The intake manifold is mounted on the side of the cylinder block in . . . . . . . . . engine.
Select an option to see the answer and solution.
Pressing down on clutch pedal causes the release levers to move the pressure plate away from
Select an option to see the answer and solution.
Which of the following is correct for super-chargers?
Select an option to see the answer and solution.
Those engines where fuel is burnt outside the combustion chamber are called-
Select an option to see the answer and solution.
The process used to give cylinder sleeve inner surface (i.e. cylinder bore surface) a cross hatch pattern is called
Select an option to see the answer and solution.
Q100
Open questionIn the transmission system, the provision of slip joints allows a change in the
Select an option to see the answer and solution.