For positive plates . . . . . . . . is pasted.
A. Lead peroxide
B. Lead antimony
C. Both of them
D. None of these
Select an option to see the answer and solution.
For battery the amount of current depends upon the following factor-
A. No. of plates
B. Area of plates
C. Temperature
D. All are correct
Select an option to see the answer and solution.
It is important that specific gravity . . . . . . . . be used to determine the degree of recharge except at the final stages.
A. Can
B. Can not
C. Remain
D. None
Select an option to see the answer and solution.
When the battery is fully charged than its specific gravity at 27° is-
A. 1.220
B. 1.175
C. 1.100
D. None
Select an option to see the answer and solution.
Which type of water is used in electrolyte?
A. Ordinary type
B. Distilled water
C. Solution of anything
D. None of these
Select an option to see the answer and solution.
Which one of the following correctly indicates the current flow sequence in the starter motor?
A. Battery - Brush - Commutator - Armature - Commutator - Brush - Field windings - Ground
B. Battery - Field Windings - Brush - Commutator - Armature - Ground
C. Battery - Field Windings - Brush - Commutator - Armature - Commutator - Brush - Ground
D. Battery - Brush - Commutator - Field windings - Armature - Commutator - Brush - Ground
Select an option to see the answer and solution.
A type of battery cell that can not be recharged is called-
A. Secondary cell
B. Primary cell
C. Both cells
D. None of these
Select an option to see the answer and solution.
A solenoid uses two coils. These are called
A. Push-in and pull-out
B. Pull-in and push-out
C. Push-in and hold-out
D. Pull-in and hold-in
Select an option to see the answer and solution.
The composition of the electrolyte in a fully charged battery is that
A. The electrolyte is pure distilled water
B. The electrolyte is a mixture of 64% distilled water and 36% sulphuric acid by weight
C. The electrolyte is a mixture of 90% distilled water and 10% sulphuric acid by weight
D. The electrolyte is pure sulphuric acid
Select an option to see the answer and solution.
The term CAN, with reference to automotive electronics, stands for
A. Controllable Artificial Networks
B. Computer Assisted Networks
C. Controller Area networks
D. None of the above
Select an option to see the answer and solution.
Green colour is used for
A. Stop lamps
B. Fuse gauge
C. Direction indicators
D. All of the above
Select an option to see the answer and solution.
For rewiring the vehicle the cable size of main battery feed circuit is-
A. 0.012 44
B. 0.012 28
C. 0.112 28
D. 0.012 14
Select an option to see the answer and solution.
In electrolyte the ratio between pure sulphuric acid and distilled water.
A. 1 : 7
B. 2 : 8
C. 1 : 10
D. 10 : 11
Select an option to see the answer and solution.
Which of the following test of primary importance with respect to the lead acid battery is-
A. Capacity test
B. High rate discharge test
C. Life cycle test
D. All are correct
Select an option to see the answer and solution.
The discharged lead-acid battery has on its plates
A. Lead peroxide
B. Spongy lead
C. Lead sulphate
D. Sulphuric acid
Select an option to see the answer and solution.
In case of an automobile battery, following are the reasons which will cause a defect of
1. Very high charging rate
2. High specific gravity of electrolyte
3. Freezing of electrolyte
4. Improper level of electrolyte
5. Mechanical damage due to rough handling or not fixed in the vehicle
A. Loss of water
B. Deterioration of plates
C. Corrosion of terminals and clamps
D. Internal short circuiting
Select an option to see the answer and solution.
The stranded wire has . . . . . . . . . resistance than solid wire.
A. More
B. Less
C. Equal
D. More or less
Select an option to see the answer and solution.
A battery usually has . . . . . . . . cells.
A. 3
B. 6
C. Both A and B
D. None of these
Select an option to see the answer and solution.
For automobile wiring which type of wire is used-
A. P. V. C.
B. Cotton braided wires
C. Both the wires
D. None of these
Select an option to see the answer and solution.
A battery can be charged by
A. Applying voltage in the reverse direction to that of charging
B. Applying a voltage in the same direction to that of discharging
C. Adding sulphuric acid
D. Adding water
Select an option to see the answer and solution.