Q101
Open questionV-eight engine was employed in
Select an option to see the answer and solution.
Automobile Engineering · all questionsIntroduction of Automobile
Introduction of Automobile
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
242
Questions
6/13
Page
Pick an option on a question to see the right answer and solution.
Q102
Open questionIn the Hotchkiss drive, the rear end torque is absorbed by the
Select an option to see the answer and solution.
Q103
Open questionWhat is the final unit in transmission system?
Select an option to see the answer and solution.
Q104
Open questionA chassis dynamometer measures the vehicle power at the
Select an option to see the answer and solution.
Q105
Open questionThe function of a universal Joint is to allow the propeller shaft to
Select an option to see the answer and solution.
Q106
Open question. . . . . . . . in an automobile is the source of power.
Select an option to see the answer and solution.
Q107
Open questionA Cabriolet is a convertible car with how many seats
Select an option to see the answer and solution.
Q108
Open questionCompared to a Homogeneous Charge Compression Ignition (HCCI) engine, the fuel injections pressure in case of Gasoline Direct Injection Compression Ignition (GDCI) engine is about
Select an option to see the answer and solution.
Q109
Open questionCritical whirling speed of a shaft is increased by
Select an option to see the answer and solution.
Q110
Open questionThe purpose of chilled passage in the crank shafts is to
Select an option to see the answer and solution.
Q111
Open questionThe number of points at which the engine-clutch gear box unit is supported on the chassis frame is
Select an option to see the answer and solution.
Q112
Open questionOne bar is equal to
Select an option to see the answer and solution.
Q113
Open questionA says that rocker arms reverse reciprocating motion while B says that rocker arms convert rotating motion to reciprocating motion. Who is right?
Select an option to see the answer and solution.
Q114
Open questionThe materials used for cylinder block are
Select an option to see the answer and solution.
Q115
Open questionThe uppermost ring on a piston is usually plated with
Select an option to see the answer and solution.
Q116
Open questionWhat are 'Air Dams'
Select an option to see the answer and solution.
Q117
Open questionAxle shaft of the three-quarter floating axle is subjected to
Select an option to see the answer and solution.
Q118
Open questionThe most commonly used supplementary restraint system (SRS) component is
Select an option to see the answer and solution.
Q119
Open questionIndian manufacturer of tractors are
Select an option to see the answer and solution.
Q120
Open questionMain part of a chassis is . . . . . . . .
Select an option to see the answer and solution.