If the speed of vehicle is doubled the air resistance is:
A. Increased by four times
B. Decreased by four times
C. Increased by two times
D. Decreased by two times
Select an option to see the answer and solution.
The coefficient of friction for the asbestos-based materials used for clutch facing is
Select an option to see the answer and solution.
What is the provision of punishment for the offense committed by a minor?
A. The guardian or owner will be held guilty
B. Imprisonment for 3 years with fine of 25000
C. Juvenile will be prosecuted under JJ Act and registration of motor vehicle will be canceled
D. All of these
Select an option to see the answer and solution.
In which of the following documents, the details of the vehicle tax are recorded?
A. R. C. Book
B. T. C. Book
C. Driving licence
D. None of the above
Select an option to see the answer and solution.
What is the remedy of the cause "short condenser"?
A. Replace with a new one
B. Set it correctly
C. Clean it
D. Fit it correctly
Select an option to see the answer and solution.
Power from the engine is transmitted to the rear wheel by which of the following method-
A. Direct coupled
B. Chain drive
C. V-belt drive
D. All are correct
Select an option to see the answer and solution.
Which of the following sensor data will the automatic air-conditioning system use to operate the compressor clutch?
A. Engine coolant temperature
B. Battery voltage
C. In-car and outside air temperature
D. Evaporator temperature and in-car temperature
Select an option to see the answer and solution.
When was the motor vehicle act passed?
Select an option to see the answer and solution.
A temporary certificate of registration is valid for a period not exceeding
A. One month
B. One year
C. Two years
D. Six months
Select an option to see the answer and solution.
The reason for using an intermediate shafts is
A. To reduce the weight of the drive shaft
B. To ensure left and right drive shafts of the same length so as to reduce the possibility of torque steering
C. To increase the suspension stroke
D. To absorb the difference in speeds of the left and right wheels
Select an option to see the answer and solution.
Total seating capacity of Maxi cabs should not exceed more than . . . . . . . . excluding the driver.
Select an option to see the answer and solution.
Electric fans of . . . . . . . . inches sweep adjustable, at least . . . . . . . . in number, suitable spaced in the passenger compartment and controlled by switches located near the seat in case of tourist vehicles, is as per CMVR 1989.
A. 7, 7
B. 8, 8
C. 9, 9
D. 10, 10
Select an option to see the answer and solution.
What percentage increase provision has been kept in the Motor Vehicle Amendment Bill 2019?
Select an option to see the answer and solution.
Which of the following should be cold during normal operation of the air-conditioning system?
A. Compressor
B. Condensor
C. Receiver and drier
D. Evaporator
Select an option to see the answer and solution.
The registration mark should be illuminated by
A. White light
B. Red light
C. Blue light
D. Green light
Select an option to see the answer and solution.
The radial motion towards the centerline of the cylinder is termed as
A. Squish
B. Turbulence
C. Tumble
D. Quench area
Select an option to see the answer and solution.
Most of the mopeds in India have capacity of
A. 100 CC
B. 50 CC
C. 150 CC
D. 120 CC
Select an option to see the answer and solution.
The purpose of corrugated fins used in condenser and evaporator is to
A. Trap insects and foreign objects, thus preventing them from entering the engine compartment
B. Control the air flow which passes through the condenser or evaporator
C. Increase the surface area, thus enhancing heat-exchange performance
D. Reinforce the heat exchanger
Select an option to see the answer and solution.
Chrysler semi-automatic transmission is a . . . . . . . . speed forward arid reverse geared semi-automatic transmission.
Select an option to see the answer and solution.
Authority to have make rule regarding the uniform for the driver of transport vehicle.
A. Central government
B. State government
C. Both
D. None
Select an option to see the answer and solution.