The purpose of air-conditioning a car is to control
A. Temperature and pressure
B. Pressure and humidity
C. Humidity and temperature
D. Temperature, pressure and humidity
Select an option to see the answer and solution.
What is the advantage of automatic transmission?
A. Simple driving control
B. Reduced fuel consumption
C. Less fatigue to driver
D. All are correct
Select an option to see the answer and solution.
Rajdoot motor cycle contains which type of chassis-
A. Tubular section
B. Integral frame
C. Box section
D. None of these
Select an option to see the answer and solution.
In case of temporary registration which of the following figure is correct?
A. In black on white ground
B. In red on yellow ground
C. Both are correct
D. None of the above
Select an option to see the answer and solution.
Which of the following is the essential devices for overdrive?
A. A free wheeling mechanism
B. A planetary gear set
C. Both are correct
D. None are correct
Select an option to see the answer and solution.
What is the fine amount kept for driving a vehicle despite disqualification
A. 15,000
B. 20,000
C. 5000
D. 10,000
Select an option to see the answer and solution.
As per CMVR 1989, the type approval of CNG kit for "Retrofitment" shall be valid for . . . . . . . . years from the date of such approval and shall be renewable for . . . . . . . . years.
A. 3, 2
B. 3, 3
C. 5, 3
D. None of the above
Select an option to see the answer and solution.
What is the cause of the trouble 'Noise in overdrive'?
A. Worn gears
B. Worn main shaft bearing
C. Both are correct
D. None are correct
Select an option to see the answer and solution.
Under the Motor Vehicle Act 2019, the time is known as 1 hour after the accident is:
A. Silver Hour
B. Platinum Hour
C. Golden Hour
D. Bronze Hour
Select an option to see the answer and solution.
What is the penalty amount for driving without insurance
A. 1000
B. 2000
C. 5000
D. 10,000
Select an option to see the answer and solution.
Liquefied petroleum gas (LPG) comprises of
A. Butane and ethane
B. Butane and propane
C. Propane and ethane
D. Methane and ethane
Select an option to see the answer and solution.
The amount of compensation is Rs. . . . . . . . . for permanent disability.
A. 7500
B. 15000
C. 5000
D. 1000
Select an option to see the answer and solution.
The registration marks are in which of the follwoing schedule?
A. First
B. Second
C. Sixth
D. Fifth
Select an option to see the answer and solution.
The scooters, motor cycles and mopeds contain the type of chassis as-
A. Tubular section
B. Integral frame
C. Box section
D. All are correct
Select an option to see the answer and solution.
The control of transport vehicle is explained in the chapter-
Select an option to see the answer and solution.
The lag of runner behind the impeller is known as-
A. Runner in
B. Runner out
C. Slip
D. None of these
Select an option to see the answer and solution.
Which of the following is the correct method to be employed in the inspection of a axle shaft boot?
A. Visually inspect the boot in its installed condition
B. Open up the folds in the boot by hand and then inspect visually, in its installed condition
C. Use a dye penetrant crack detector
D. Use soapy water
Select an option to see the answer and solution.
Which of the statement is correct with regard to a manual air-conditioning system?
A. The air-conditioning system must be turned off manually if full engine power is necessary for accelerating
B. Although the driver or passenger can select the blower fan speed and the vent opening, the temperature cannot be adjusted
C. The driver or passenger can adjust the cooling performance. However, it is not possible to set a specific temperature which will be maintained constantly
D. The driver or passenger can adjust the temperature by changing the temperature setting valve
Select an option to see the answer and solution.
The miscellaneous contains the sections-
A. 132A - 135
B. 71 - 91
C. 21A - 21J
D. 3 - 21
Select an option to see the answer and solution.
The wiper motor is of
A. Series wound type
B. Shunt wound type
C. Series and shunt wound type
D. Series and parallel wound type
Select an option to see the answer and solution.