Automobile Engineering · all questions

Transmission System
practice.

Practice every MCQ with options. Use Show answers when you want the correct option and solution.

139

Questions

7/7

Page

Pick an option on a question to see the right answer and solution.

Q121

Which part of engine is having connection with pinion of starting motor?

Select an option to see the answer and solution.

Q122

The creep in belt drive is due to the

Select an option to see the answer and solution.

Q123

The power transmitted by a belt drive is maximum when the centrifugal tension as compared to the maximum tension is

Select an option to see the answer and solution.

Q124

When vehicle is cornering, the crown wheel is rotating at 400 rev/min. and the outer wheel is running at 420 rev/min, then the speed of the inner wheel of the final drive will be

Select an option to see the answer and solution.

Q125

To tum the drive at 90° and to give the required speed reduction, the basic type of gearing is-

Select an option to see the answer and solution.

Q126

What is the ratio of final reduction shift position?

Select an option to see the answer and solution.

Q127

What is a type of propeller shafts?

Select an option to see the answer and solution.

Q128

The result of an increase in the drive pulley diameter and a decrease in the driven pulley diameter is

Select an option to see the answer and solution.

Q129

A differential gear in an automobile is a

Select an option to see the answer and solution.

Q130

Constant velocity joints are used when the angle of drive is more than-

Select an option to see the answer and solution.

Q131

The transversely mounted engine does not require its final drive turned through-

Select an option to see the answer and solution.

Q132

A four-speed gear box provides-

Select an option to see the answer and solution.

Q133

Engine torque fluctuations in a typical single plate clutch are absorbed by . . . . . . . .

Select an option to see the answer and solution.

Q134

Which is a cross-shaped member of a cross and yoke type universal joint?

Select an option to see the answer and solution.

Q135

When the axle moves up and down from its normal position the distance between the output flange of gearbox and input flange of differential-

Select an option to see the answer and solution.

Q136

Limited slip differential is essential in

Select an option to see the answer and solution.

Q137

A flywheel in an Ie engine

Select an option to see the answer and solution.

Q138

In gear drive, rotary motion is changed into linear motion and vice-versa is possible by using

Select an option to see the answer and solution.

Q139

The transfer case is essentially a . . . . . . . . speed transmission.

Select an option to see the answer and solution.