The diameter of base of conical flare of a steel stack is (where d is the diameter of the cylindrical part)
Select an option to see the answer and solution.
Civil Engineering · all questionsDesign Of Steel Structures
Design Of Steel Structures
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
112
Questions
3/6
Page
Pick an option on a question to see the right answer and solution.
A butt weld is specified by
Select an option to see the answer and solution.
The bracing provided in the plane of end posts is called
Select an option to see the answer and solution.
The allowable shear stress in the web of mild steel beams decreases with (where 'h' is height and 't' is thickness)
Select an option to see the answer and solution.
For a compression member with double angle section, which of the following section will give larger value of minimum radius of gyration?
Select an option to see the answer and solution.
According to IS Specifications, the effective length of a column effectively held in position at both ends and restrained in direction at one end is taken as
Select an option to see the answer and solution.
compression force in two end posts The pin of a rocker bearing in a bridge is designed for
Select an option to see the answer and solution.
According to IS Specifications, the maximum pitch of rivets in compression is (where t is thickness of thinnest outside plate or angle)
Select an option to see the answer and solution.
As compared to field rivets, the shop rivets are
Select an option to see the answer and solution.
Which of the following sections should preferably be used at places where torsion occurs?
Select an option to see the answer and solution.
When the bolts are subjected to reversal of stresses, the most suitable type of bolt is
Select an option to see the answer and solution.
Minimum thickness of web in a plate girder, when the plate is accessible and also exposed to weather, is
Select an option to see the answer and solution.
The best arrangement to provide unified behaviour in built up steel columns is by
Select an option to see the answer and solution.
The maximum spacing of vertical stiffeners is (where d is the distance between flange angles)
Select an option to see the answer and solution.
Minimum spacing of vertical stiffeners is limited to (where d is the distance between flange angles)
Select an option to see the answer and solution.
Which of the following types of riveted joint is free from bending stresses?
Select an option to see the answer and solution.
The risk coefficient k, depends on
Select an option to see the answer and solution.
Economical depth of a plate girder corresponds to
Select an option to see the answer and solution.
Angle of inclination of the lacing bar with the longitudinal axis of the column should preferably be between
Select an option to see the answer and solution.
The maximum slenderness ratio of a compression member carrying both dead and superimposed load is
Select an option to see the answer and solution.