By which of the following a bus-bar is rated?
Select an option to see the answer and solution.
Electrical Engineering · all questionsTransmission And Distribution
Transmission And Distribution
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
105
Questions
1/6
Page
Pick an option on a question to see the right answer and solution.
Which of the following equipment, for regulating the voltage in distribution feeder, will be most economical?
Select an option to see the answer and solution.
The frequency of voltage generated, in case of generators, can be increased by
Select an option to see the answer and solution.
In aluminium conductors, steel core is provided to
Select an option to see the answer and solution.
Overhead system can be designed for operation up to
Select an option to see the answer and solution.
Pin type insulators are generally not used for voltages beyond
Select an option to see the answer and solution.
Which of the following is usually not the generating voltage?
Select an option to see the answer and solution.
When the interconnector between two stations has large reactance
Select an option to see the answer and solution.
Distribution lines in India generally use
Select an option to see the answer and solution.
A 3-phase 4-wire system is commonly used on
Select an option to see the answer and solution.
Which of the following regulations is considered best?
Select an option to see the answer and solution.
Overhead lines generally use
Select an option to see the answer and solution.
By which of the following systems electric power may be transmitted?
Select an option to see the answer and solution.
Low voltage cables are meant for use up to
Select an option to see the answer and solution.
Transmitted power remaining the same, if supply voltage of a D.C. 2-wire feeder is increased 100 percent, saving in copper is
Select an option to see the answer and solution.
Aluminium has a specific gravity of
Select an option to see the answer and solution.
In AC.S.R. Conductors, the insulation between aluminium and steel conductors is
Select an option to see the answer and solution.
A uniformly loaded D.C. distributor is fed at both ends with equal voltages. As compared to a similar distributor fed at one end only, the drop at the middle point is
Select an option to see the answer and solution.
The current drawn by the line due to corona losses is
Select an option to see the answer and solution.
are the conductors, which connect the consumer's terminals to the distribution
Select an option to see the answer and solution.