Vidyalelo
ECE · all questions

Materials And Components
practice.

Practice every MCQ with options. Use Show answers when you want the correct option and solution.

248

Questions

8/13

Page

Pick an option on a question to see the right answer and solution.

Which one of the following is a metallic crystal structure which has a cubic unit cell with atoms located at all eight corners and a single atom at the cube centre?

Select an option to see the answer and solution.

Which of the following materials are categories of ceramic materials?
1. Oxides-alumina, Zirconia
2. Non-oxides-Carbides, Borides, Nitrides and Silicides
3. Composites- Particulate reinforced combinations of oxides and non-oxides
Select the correct answer using the options given below:

Select an option to see the answer and solution.

An intense magnetic field is to be produced by a superconducting coil. Which one of the following is essential?

Select an option to see the answer and solution.

Superconductivity is observed for

Select an option to see the answer and solution.

Consider the following statements regarding the effect of temperature on the dielectric constant of an insulator.
1. The dielectric constant increases due to thermal energy facilitating the alignment of the dipole with the applied field.
2. The dielectric constant decrease due to the randomizing effect of thermal energy.
3. The dielectric constant decreases due to an increase in the volume of the material.
4. The dielectric constant increases due to the creation of new dipoles.
Of these statements

Select an option to see the answer and solution.

Type-I classified superconducting materials on the basis of magnetic response are completely in diamagnetic state where magnetic field is excluded from the body of material due to the phenomenon, known as

Select an option to see the answer and solution.

Which of the following insulating materials has the least affinity for moisture?

Select an option to see the answer and solution.

If the drift velocity of holes under a field gradient of 200 V/m is 100 m/s, their mobility in SI units is

Select an option to see the answer and solution.

Which one of the following is a trivalent material?

Select an option to see the answer and solution.

Which of the following are the properties of poly tetra fluoroethyene?
1. Extreme heat resistant
2. Low resistance to most chemical reagents
3. Excellent insulating properties over a wide range of temperature
4. Non-hygroscopicity
Select the correct answer using the options given below:

Select an option to see the answer and solution.

Consider the following statements with regard to FCC structure:
1. Number of nearest neighbour atoms is twelve.
2. Packing efficiency is 0.74.
3. There is an atom at the body centre of the unit cell.
Which of the statements given above is/are correct?

Select an option to see the answer and solution.

Pure Metals generally have

Select an option to see the answer and solution.

Electrical conductivity, thermal conductivity and magnetic properties of ceramic material are

Select an option to see the answer and solution.

Forbidden gap in a semiconductor is

Select an option to see the answer and solution.

Which one of the following does not come under the category of ceramic material?

Select an option to see the answer and solution.

Polyethylene is produced by

Select an option to see the answer and solution.

What are the materials which exhibit electric polarization even in the absence of an applied electric field called?

Select an option to see the answer and solution.

The structure sensitive property of a superconductor is

Select an option to see the answer and solution.

A hetero-structure laser is better than a diode laser (injection laser) because of its

Select an option to see the answer and solution.

Match List-I with List-II and select the correct answer using the options given below:
List-I (Material) List-II (Properties)
a. Superconductor at very low temperature 1. High frequency
b. Fabric chloride 2. Very small -ve susceptibility
c. Diamond 3. Very high -ve susceptibility
d. Manganese oxide 4. Susceptibility is inversely proportional to +θ
(Here T is temperature of the material in Kelvin. θ is a constant for a material).

Select an option to see the answer and solution.