In satellite communication, scrambling is mainly used for-
A. clock recovery
B. encryption
C. limiting power spectral density
D. bandwidth efficiency
Select an option to see the answer and solution.
For an orbiting satellite, in magnitude
A. The kinetic energy is equal to the potential energy
B. The kinetic energy is twice the potential energy
C. The kinetic energy is half the potential energy
D. The kinetic energy is one- fourth the potential energy
Select an option to see the answer and solution.
A television (TV) transmission using satellite is an example of which type of transmission?
1. Half duplex
2. Full duplex
3. Simplex
A. 1, 2 and 3
B. 1 only
C. 2 only
D. 3 only
Select an option to see the answer and solution.
A satellite communication link has uplink C/N0 of 50 dB-Hz and downlink C/N0 of 47 dB-Hz. What would be overall link C/N0 ?
A. 44 dB-Hz
B. 45 dB-Hz
C. 48.5 dB-Hz
D. 53 dB-Hz
Select an option to see the answer and solution.
Expensive tracking equipment is not requires for:
A. Low earth orbit satellite LEO
B. Medium earth orbit satellite MEO
C. Geosynchronous earth orbit GEO satellite
D. All the above three types
Select an option to see the answer and solution.
What was the first commercial geostationary communication satellite?
A. INTELSAT 1
B. ECHO
C. INSAT-TA
D. SPUTNIK
Select an option to see the answer and solution.
One of the following is found on board a weather satellite
A. VHRR (Very high resolution radiometer)
B. Transponder
C. Telescope
D. High resolution camera
Select an option to see the answer and solution.
The number of Active transponders are carried by a high capacity satellite are
A. 10-12 transponders
B. 12-44 transponders
C. 12-18 transponders
D. 16-44 transponders
Select an option to see the answer and solution.
If the peak transmitted power in a radar system is increased by a factor of 16, the maximum range will be increased by a factor of
Select an option to see the answer and solution.
A radar system uses a rotating antenna
A. determine the target range
B. determine the target bearing
C. identify the target
D. determine target velocity
Select an option to see the answer and solution.
Range resolution of a Linear Frequency Modulated pulse compression radar depends on which of the following factors:
A. Radiated power
B. Antenna size
C. Center frequency of the radar
D. Bandwidth of the transmitted pulse
Select an option to see the answer and solution.
In satellite communication, Faraday rotation is caused by
A. Plasma frequency
B. Earth's magnetic field
C. Non-Gaussian nature of uplink noise when received in the downlink channel
D. Ionospheric reflections that occur multiple times
Select an option to see the answer and solution.
The usable bandwidth of a microwave because transponder for 6/4 satellite communication is generally
A. 360 MHz
B. 40 MHz
C. 36 MHz
D. 1 MHz
Select an option to see the answer and solution.
The maximum range of a monostatic Radar is R. If a target having a Radar cross-section of 10 m2 exists at R/2, what should be the target cross-section at 3R/2 to result in an equal signal strength at the Radar?
A. 90 m2
B. 270 W/m2
C. 810 m2
D. 30 W/m2
Select an option to see the answer and solution.
An FM-CW (Frequency Modulated - Continuous Wave) Radar is essentially
A. Bistatic
B. Monostatic
C. Can operate either as monostatic or as bistatic
D. None of the above
Select an option to see the answer and solution.
Which of the following statements on communication by geosynchronous satellites are correct?
1. The propagation loss over each direction (uplink are downlink) is about 200 dB at 5 GHz.
2. Radius of the geosynchronous orbit is 42250 km.
3. An arc of about 17° must be covered by the satellite antenna in the equatorial plane.
4. The polar regions are well covered by the satellite antenna.
Select the correct answer using the options given below:
A. 1, 2 and 4
B. 2 and 3
C. 1 and 4
D. 1, 2 and 3
Select an option to see the answer and solution.