What does UCS stand for in rock mechanics?
Select an option to see the answer and solution.
Geological Engineering · all questionsRock Mechanics and Rock Engineering
Rock Mechanics and Rock Engineering
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
150
Questions
1/8
Page
Pick an option on a question to see the right answer and solution.
Which test is commonly used to determine tensile strength of rock?
Select an option to see the answer and solution.
Rock mass rating (RMR) system is used for:
Select an option to see the answer and solution.
What does the term �anisotropy� in rock mechanics refer to?
Select an option to see the answer and solution.
What is the typical unit of UCS in SI?
Select an option to see the answer and solution.
Which of the following influences the strength of a rock mass more than intact rock strength?
Select an option to see the answer and solution.
What is the slake durability test used for?
Select an option to see the answer and solution.
The angle between the normal stress and shear stress in Mohr�s Circle is:
Select an option to see the answer and solution.
Which failure criterion is most widely used in rock mechanics?
Select an option to see the answer and solution.
What does GSI stand for in rock engineering?
Select an option to see the answer and solution.
Which property is measured using a Schmidt hammer?
Select an option to see the answer and solution.
What does a high Poisson�s ratio in rock indicate?
Select an option to see the answer and solution.
Rock bolting is primarily used for:
Select an option to see the answer and solution.
The deformation modulus of rock mass is:
Select an option to see the answer and solution.
Which parameter does NOT influence rock slope stability?
Select an option to see the answer and solution.
What is the primary cause of rock bursts in deep tunnels?
Select an option to see the answer and solution.
The term �creep� in rock mechanics refers to:
Select an option to see the answer and solution.
Which type of failure is common in heavily jointed rock masses?
Select an option to see the answer and solution.
What is the unit of Rock Mass Rating (RMR)?
Select an option to see the answer and solution.
Which type of stress is usually most responsible for tensile cracking in rocks?
Select an option to see the answer and solution.