The condition of a part when it contains the least amount of material is referred to as ________.
Select an option to see the answer and solution.
Mechanical Engineering · all questionsEngineering Drawing
Engineering Drawing
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
255
Questions
5/13
Page
Pick an option on a question to see the right answer and solution.
The typical parts list should include the _________.
Select an option to see the answer and solution.
The title block used on working drawings should include the _________.
Select an option to see the answer and solution.
The thread note for a typical bolt will include the _________.
Select an option to see the answer and solution.
Several of the tools used in traditional drafting include the following:
Select an option to see the answer and solution.
The standard number of threads per inch for various diameters is the:
Select an option to see the answer and solution.
Architectural dimensioning is usually done in ________.
Select an option to see the answer and solution.
The bounding box method for setting up an isometric drawing helps the drafter ________.
Select an option to see the answer and solution.
When creating your own blocks it is important to avoid drawing any portion of the block in the ________ layer.
Select an option to see the answer and solution.
There should be a visible gap between the wall and the _________ line.
Select an option to see the answer and solution.
This is the theoretically exact size from which limits of size are determined:
Select an option to see the answer and solution.
In the section view, the areas that would have been in actual contact with the cutting plane are shown with:
Select an option to see the answer and solution.
A partial auxiliary view is used to show only the __________ in the auxiliary view.
Select an option to see the answer and solution.
In this type of dimensioning, allowance must be made for bends:
Select an option to see the answer and solution.
One way to evenly space dimensions on a drawing is to use the __________.
Select an option to see the answer and solution.
In this type of auxiliary view, a break line is used to indicate the imaginary break in the views:
Select an option to see the answer and solution.
Students can complete an associate's degree in drafting which normally takes about __________ years to complete.
Select an option to see the answer and solution.
This is an angled surface used on cylinders to make them easier to handle:
Select an option to see the answer and solution.
The ________ is a standard element of a section view in a technical drawing.
Select an option to see the answer and solution.
Q100
Open questionThese gears transmit power between shafts whose axes intersect at any angle:
Select an option to see the answer and solution.