Q541
Open questionFor a square key made of mild steel, the shear and crushing strength are related as
Select an option to see the answer and solution.
Mechanical Engineering · all questionsMachine Design
Machine Design
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
605
Questions
28/31
Page
Pick an option on a question to see the right answer and solution.
Q542
Open questionThe dynamic tooth load is due to
Select an option to see the answer and solution.
Q543
Open questionWhen the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be
Select an option to see the answer and solution.
Q544
Open questionThe permissible stress in the fillet weld is 100 N/mm². The fillet weld has equal leg lengths of 15 mm each. The allowable shearing load on the weldment per cm length of the weld is
Select an option to see the answer and solution.
Q545
Open questionIn a partial journal bearing, the angle of contact of the bearing with the journal is
Select an option to see the answer and solution.
Q546
Open questionIn a full journal bearing, the angle of contact of the bearing with the journal is
Select an option to see the answer and solution.
Q547
Open questionIf a bearing is designated by the number 305, it means that the bearing is of
Select an option to see the answer and solution.
Q548
Open questionIn a flat belt drive, if the slip between the driver and belt is 1%, between the belt and follower is 3% and driver and follower pulley diameters are equal, then velocity ratio of the drive will be
Select an option to see the answer and solution.
Q549
Open questionThe static tooth load should be __________ the dynamic load.
Select an option to see the answer and solution.
Q550
Open questionThe wear load should be __________ the dynamic load.
Select an option to see the answer and solution.
Q551
Open questionIn designing a key, it is assumed that the distribution of forces along the length of key
Select an option to see the answer and solution.
Q552
Open questionThe bearings of medium series have capacity __________ over the light series.
Select an option to see the answer and solution.
Q553
Open questionIf the size of a standard specimen for a fatigue testing machine is increased, the endurance limit for the material will
Select an option to see the answer and solution.
Q554
Open questionThe effective stress in wire ropes during normal working is equal to the stress due to
Select an option to see the answer and solution.
Q555
Open questionWhen bevel gears connect two shafts whose axes intersect at an angle greater than a right angle and one of the bevel gears has a pitch angle of 90°, then they are known as
Select an option to see the answer and solution.
Q556
Open questionWhen bevel gears having equal teeth and equal pitch angles connect two shafts whose axes intersect at right angle, then they are known as
Select an option to see the answer and solution.
Q557
Open questionThe crest diameter of a screw thread is same as
Select an option to see the answer and solution.
Q558
Open questionThe maximum efficiency of a square threaded screw is
Select an option to see the answer and solution.
Q559
Open questionIn order to have a connecting rod equally strong in buckling about X-axis and Y-axis, the moment of inertia about X-axis should be __________ the moment of inertia about Y-axis.
Select an option to see the answer and solution.
Q560
Open questionThe connecting rod bolts are tightened up so that tightening stress
Select an option to see the answer and solution.