The extending the polymer chain by successive addition of monomers units is called
Select an option to see the answer and solution.
Metallurgical Engineering · all questionsMiscellaneous in Metallurgy
Miscellaneous in Metallurgy
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
252
Questions
1/13
Page
Pick an option on a question to see the right answer and solution.
Dacron is an example of
Select an option to see the answer and solution.
If Reynolds number is greater than 1, then the
Select an option to see the answer and solution.
Which is the correct (degree) temperature range for spherodized carbide in low carbon steel
Select an option to see the answer and solution.
Which of the following torch angle used in the forehand welding process
Select an option to see the answer and solution.
The Nusselt number depends only on the Rayleigh number (product of the Grashof and Prandtl numbers) in the limit of
Select an option to see the answer and solution.
Which of the following has a greater impact on the longitudinal strength of reinforced composites
Select an option to see the answer and solution.
For ferrous drawing, the drawing speed of multiple die machine is
Select an option to see the answer and solution.
For edge dislocation slip plane is
Select an option to see the answer and solution.
Match the items in Group 1 with units/dimensions in Group 2.
| Group 1 | Group 2 |
| P. Diffusivity | 1. Lt-1 |
| Q. Surface tension | 2. L-2t-1 |
| R. Dislocation density | 3. JL-2 |
| S. Mass Transfer coefficient | 4. J mol-1.K-1 |
| 5. L-2 |
Select an option to see the answer and solution.
At a particular extrusion ratio, the strength . . . . . . . . along the length of the extruded product from front to back end.
Select an option to see the answer and solution.
Probability of nucleation throughout the system is . . . . . . . . In heterogeneous nucleation.
Select an option to see the answer and solution.
A glass fibre reinforced epoxy composite is made with 60 wt.% unidirectional continuous glass fibres. The elastic moduli of the glass fibre and the epoxy matrix are 72.5 and 2.4 GPa, respectively. What is the elastic modulus of this composite along the fibre direction, in GPa? The densities of glass fibre and epoxy are 2.58 g/cm3 and 1.14 g/cm3, respectively
Select an option to see the answer and solution.
The the equation for thermal conductivity
Select an option to see the answer and solution.
Example/examples of eutectoid system is/are
Select an option to see the answer and solution.
The resistance to compressive deformation increases when length to thickness
Select an option to see the answer and solution.
Hardness of steel increases with the
Select an option to see the answer and solution.
The motion of edge dislocation inside the materials may be
Select an option to see the answer and solution.
The infinitely long and wide parallel plates A and B are at temperature. Ta and Tb respectively. The energy transferred from relatively hotter plate A to plate B is proportional to
Select an option to see the answer and solution.
A steel rod was subjected to a fluctuating stress cycle that varied between a maximum of 400 MPa in tension to a minimum of 300 MPa in compression. What is the stress amplitude, in MPa?
Select an option to see the answer and solution.