The value of R for i = 2A is
Select an option to see the answer and solution.
A mathematical expression for 50 Hz sinusoidal voltage of peak value of 80 V will be
A. V = 50sin314t
B. V = 50sin80t
C. V = 80sin314t
D. V = 80sin50t
Select an option to see the answer and solution.
A coil of inductance 2 H and resistance 1 Ω is connected to a 10 V battery with negligible internal resistance. The amount of energy stored in the magnetic field is
Select an option to see the answer and solution.
Two coils have self-inductances of 0.09 H and 0.01 H and a mutual inductance of 0.015 H. The coefficient of coupling between the coils is
Select an option to see the answer and solution.
Which among the following condition is true at the resonance?
A. Xc > XL
B. Xc = XL
C. Xc < XL
D. None of the above
Select an option to see the answer and solution.
One electron volt is equal to
A. 1.6 × 10-19 Joule
B. 54.6 × 10-9 Joule
C. 4.6 × 10-12 Joule
D. 1.3 × 10-7 Joule
Select an option to see the answer and solution.
The short-circuit admittance matrix of a two-port network is \left[ {\begin{array}{*{20}{c}}
0&{ - \frac{1}{2}} \\
{\frac{1}{2}}&0
\end{array}} \right]
The two-port network is
A. non-reciprocal and passive
B. non-reciprocal and active
C. reciprocal and passive
D. reciprocal and active
Select an option to see the answer and solution.
The use of notch filter in signal conditioning system is to
A. filter R.F. noise
B. filter 50 Hz noise from mains
C. filter the signal from various noises
D. attenuate the evolved response potentials
Select an option to see the answer and solution.
The time constant for the circuit shown below is
A. 0.2 Microsecond
B. 0.8 millisecond
C. 0.4 millisecond
D. 0.2 milisecond
Select an option to see the answer and solution.
Differentiator circuit is also works as-
A. All pass filter
B. Band pass filter
C. High pass filter
D. Low pass filter
Select an option to see the answer and solution.
In a prototype filter the series arm and shunt arm impedance should be
A. Zero
B. Resistive
C. Reactive and same type
D. Reactive and opposite type
Select an option to see the answer and solution.
Power factor is the ratio of
A. Active Power Apparent Power
B. Apparent Power Active Power
C. Real Power Complex Power
D. Complex Power Reactive Power
Select an option to see the answer and solution.
In an AC circuit, the voltage source V is as follows: V = 100sin(100t) volt. The rms value of voltage is
A. 35.35 V
B. 40.35 V
C. 80.7 V
D. 70.7 V
Select an option to see the answer and solution.
A Coil consists of 750 turns and current of 10 A in the coil give rise to a magnetic flux of 1.2 mWb. Calculate the inductance of the coil?
A. L = 0.09 H
B. L = 1 H
C. L = 0.12 H
D. L = 10 H
Select an option to see the answer and solution.
Three elements having conductance G1 , G2 and G3 are connected in parallel. Their combined conductance will be
A. G 1 1 + G 2 1 + G 3 1 1
B. G 1 + G 2 + G 3 G 1 G 2 + G 2 G 3 + G 3 G 1
C. G 1 + G 2 + G 3 1
D. G 1 + G 2 + G 3
Select an option to see the answer and solution.
Which of the following is a passive component?
A. Semi-conductor device
B. Vacuum tube device
C. Capacitors
D. All of these
Select an option to see the answer and solution.
A two branch parallel circuit has a 20 Ω resistance and 1 H inductance in one branch and a 100 µF capacitor in the second branch. It is fed from 100 V ac supply, at resonance, the input impedance of the circuit is
Select an option to see the answer and solution.
The Y-parameter matrix (mA/V) of the two port network in figure is
A. \left( {\begin{array}{*{20}{c}}
2&{ - 1} \\
{ - 1}&2
\end{array}} \right)
B. \left( {\begin{array}{*{20}{c}}
2&1 \\
{ - 1}&2
\end{array}} \right)
C. \left( {\begin{array}{*{20}{c}}
1&{ - 2} \\
{ - 2}&1
\end{array}} \right)
D. \left( {\begin{array}{*{20}{c}}
2&1 \\
1&2
\end{array}} \right)
Select an option to see the answer and solution.
The impedance parameters of a two network are Z11 = 6 Ω, Z22 = 4 Ω, Z12 = Z21 = 3 Ω. What are the equivalent ABCD parameters?
A. A = 5, B = 5, C = 3 1 , D = 3 4
B. A = 1, B = 5, C = 3 1 , D = 3 4
C. A = 2, B = 5, C = 3 1 , D = 3 4
D. A = 2, B = 3, C = 5, D = 1
Select an option to see the answer and solution.
A square pulse of 3 volts amplitude is applied to C-R circuit shown in the figure. The capacitor is initially uncharged. The output voltage V
2 at time t = 2 sec is
Select an option to see the answer and solution.