Q201
Open questionI.S. specifies following total number of grades of tolerances
Select an option to see the answer and solution.
Mechanical Engineering · all questionsMachine Design
Machine Design
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
605
Questions
11/31
Page
Pick an option on a question to see the right answer and solution.
Q202
Open questionWhen a bolt and nut is made of mild steel, then the effective height of nut is made equal to (where d = Nominal diameter of bolt)
Select an option to see the answer and solution.
Q203
Open questionThe function of cutting oil when threading a pipe is to
Select an option to see the answer and solution.
Q204
Open questionThe dedendum is the radial distance from the
Select an option to see the answer and solution.
Q205
Open questionIf threads on a bolt are left hand, threads on nut will be
Select an option to see the answer and solution.
Q206
Open questionIf a load W is applied instantaneously on a bar; Then the stress induced in bar will
Select an option to see the answer and solution.
Q207
Open questionPlastic flow in ductile materials
Select an option to see the answer and solution.
Q208
Open questionWhich of the following screw thread is used for power transmission in one direction only?
Select an option to see the answer and solution.
Q209
Open questionWhen a close coiled helical spring is compressed, its wire is subjected to
Select an option to see the answer and solution.
Q210
Open questionIn levers, leverage is the ratio of
Select an option to see the answer and solution.
Q211
Open questionThe shear plane in case of bolts should
Select an option to see the answer and solution.
Q212
Open questionIn case of V belt drive
Select an option to see the answer and solution.
Q213
Open questionIn a multiple V-belt drive, when a single belt is damaged, it is preferable to change the complete set in order to
Select an option to see the answer and solution.
Q214
Open questionThe allowable static stress for steel gears is approximately __________ of the ultimate tensile stress.
Select an option to see the answer and solution.
Q215
Open questionIn a butt welded joint, the size of weld is __________ the throat of weld.
Select an option to see the answer and solution.
Q216
Open questionIn a transverse fillet welded joint, the size of weld is __________ the throat of weld.
Select an option to see the answer and solution.
Q217
Open questionThe radial distance of a tooth from the pitch circle to the top of the tooth is called
Select an option to see the answer and solution.
Q218
Open questionWhen the screw in a mechanical screw jack rotates, the load kept on the top of it moves
Select an option to see the answer and solution.
Q219
Open questionIf a material fails below its yield point, failure would be due to
Select an option to see the answer and solution.
Q220
Open questionIn a steam engine, the piston rod is usually connected to the cross-head by means of a
Select an option to see the answer and solution.