The carbide tools operating at very low cutting speeds (below 30 m/min)
Select an option to see the answer and solution.
Mechanical Engineering · all questionsManufacturing And Production Technology
Manufacturing And Production Technology
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
416
Questions
1/21
Page
Pick an option on a question to see the right answer and solution.
The type of reamer used for reaming operation in a blind hole, is
Select an option to see the answer and solution.
Stellite preserves hardness up to a temperature of
Select an option to see the answer and solution.
High speed steel tools retain their hardness up to a temperature of
Select an option to see the answer and solution.
For machining a mild steel workpiece using carbide tool, the maximum material will be removed at a temperature of
Select an option to see the answer and solution.
In a CNC program block, N002 GO2 G91 X40 Z40......, GO2 and G91 refer to
Select an option to see the answer and solution.
In an interchangeable assembly, shafts of size 25.000 -0.0100⁺⁰∙⁰⁴⁰ mm mate with holes of size 25.000 -0.010⁺⁰∙⁰²⁰ mm. The maximum possible clearance in the assembly will be
Select an option to see the answer and solution.
In determining the various forces on the chip, Merchant assumed that the
Select an option to see the answer and solution.
In order to achieve a specific surface finish in single point turning, the most important factor to be controlled is
Select an option to see the answer and solution.
The factor responsible for the formation of continuous chips with built up edge is
Select an option to see the answer and solution.
The material which on machining produces chips with built up edge is
Select an option to see the answer and solution.
A 15 mm drilling machine means that it can drill a hole
Select an option to see the answer and solution.
The binding material used in cemented carbide tools is
Select an option to see the answer and solution.
In the relation VTn = C, the value of n for carbide tools is
Select an option to see the answer and solution.
In the relation VTn = C, the value of n for ceramic tools is
Select an option to see the answer and solution.
For machining a cast iron workpiece by a high speed steel tool, the average cutting speed is
Select an option to see the answer and solution.
For machining a mild steel workpiece by a high speed steel tool, the average cutting speed is
Select an option to see the answer and solution.
The specific cutting energy used for establishing the machinability of the metal depends upon its
Select an option to see the answer and solution.
The cutting speed of a drill depends upon the
Select an option to see the answer and solution.
The size of abrasive grain required in a grinding wheel depends upon the
Select an option to see the answer and solution.