The tail stock set over method of taper turning is preferred for
Select an option to see the answer and solution.
Mechanical Engineering · all questionsManufacturing And Production Technology
Manufacturing And Production Technology
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
416
Questions
3/21
Page
Pick an option on a question to see the right answer and solution.
In a metal arc welding process, metal transfer across the arc may take place by a method of material transfer where the metal transfers across the arc is in larger drops. This is at the rate of 100 drops/sec or less, what is this known as
Select an option to see the answer and solution.
A fine grained grinding wheel is used to grind
Select an option to see the answer and solution.
A coarse grained grinding wheel is used to grind
Select an option to see the answer and solution.
When the end of a tap is tapered for about three or four threads, it is known as a
Select an option to see the answer and solution.
Which one of the following is a solid state joining process?
Select an option to see the answer and solution.
The angle between the lathe centres is
Select an option to see the answer and solution.
The taper on the lathe spindle is
Select an option to see the answer and solution.
In _________ operation, the cutting force is maximum when the tooth begins its cut and reduces it to minimum when the tooth leaves the work.
Select an option to see the answer and solution.
In a single point turning operation with a cemented carbide and steel combination having a Taylor exponent of 0.25, if the cutting speed is halved, then tool life will become
Select an option to see the answer and solution.
The factor considered for evaluation of machinability is
Select an option to see the answer and solution.
When the temperature of a solid metal increases,
Select an option to see the answer and solution.
In lapping operation, the amount of metal removed is
Select an option to see the answer and solution.
In metal machining, the zone where the maximum heat is generated due to the plastic deformation of metal, is called
Select an option to see the answer and solution.
Which of the following operations can be performed with milling cutters?
Select an option to see the answer and solution.
Volume of a cube of side ‘’ and volume of a sphere of radius ‘r’ are equal. Both the cube and the sphere are solid and of same material. They are being cast. The ratio of the solidification time of the cube to the same of the sphere is
Select an option to see the answer and solution.
The maximum production of small and slender parts is done by
Select an option to see the answer and solution.
The method of centre less grinding used to produce taper is
Select an option to see the answer and solution.
In a milling operation, two side milling cutters are mounted with a desired distance between them so that both sides of a workpiece can be milled simultaneously. This set up is called
Select an option to see the answer and solution.
A tool used to withdraw a drill from the sleeve is called
Select an option to see the answer and solution.