Q181
Open questionThe method of grinding used to produce internal cylindrical holes and tapers, is
Select an option to see the answer and solution.
Mechanical Engineering · all questionsManufacturing And Production Technology
Manufacturing And Production Technology
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
416
Questions
10/21
Page
Pick an option on a question to see the right answer and solution.
Q182
Open questionGlazing in grinding wheels takes place when the
Select an option to see the answer and solution.
Q183
Open questionGrinding wheels should be tested for balance
Select an option to see the answer and solution.
Q184
Open questionIf the diameter of the hole is subject to considerable variation, then for locating in jigs and fixtures, the pressure type of locator used is
Select an option to see the answer and solution.
Q185
Open questionThe tool life is affected by
Select an option to see the answer and solution.
Q186
Open questionThe abrasive slurry used in ultrasonic machining contains fine particles of
Select an option to see the answer and solution.
Q187
Open questionFixtures are used
Select an option to see the answer and solution.
Q188
Open questionWhich of the following is the correct data structure for solid models?
Select an option to see the answer and solution.
Q189
Open questionThe cutting fluid mostly used for machining alloy steels is
Select an option to see the answer and solution.
Q190
Open questionTwo streams of liquid metal which are not hot enough to fuse properly result into a casting defect known as
Select an option to see the answer and solution.
Q191
Open questionGear lapping is an operation
Select an option to see the answer and solution.
Q192
Open questionIn a particular type of welding, flux is prepared in the form of a coarse powder and granulated flux is spread over the joint. What is this type of welding process called?
Select an option to see the answer and solution.
Q193
Open questionThe process of improving the cutting action of the grinding wheel is called
Select an option to see the answer and solution.
Q194
Open questionA solid cylinder of diameter 100 mm and height 50 mm is forged between two frictionless flat dies to a height of 25 mm. The percentage change in diameter is
Select an option to see the answer and solution.
Q195
Open questionIn oblique cutting of metals, the cutting edge of the tool is
Select an option to see the answer and solution.
Q196
Open questionThe lip clearance angle is the angle formed by the
Select an option to see the answer and solution.
Q197
Open questionThe usual value of the helix angle of a drill is
Select an option to see the answer and solution.
Q198
Open questionIn drilling Bakelite and fibrous plastics, the point angle of a drill is
Select an option to see the answer and solution.
Q199
Open questionThe usual value of the point angle of a drill is
Select an option to see the answer and solution.
Q200
Open questionThe guide-ways are of
Select an option to see the answer and solution.