Q301
Open questionThe relation between tool life (T) and cutting speed (V) is VTn = Constant. In this relation, the value of n depends upon
Select an option to see the answer and solution.
Mechanical Engineering · all questionsManufacturing And Production Technology
Manufacturing And Production Technology
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
416
Questions
16/21
Page
Pick an option on a question to see the right answer and solution.
Q302
Open questionIn machining metals, chips break due to __________ of work material.
Select an option to see the answer and solution.
Q303
Open questionAs the cutting speed increases, the tool cutting forces
Select an option to see the answer and solution.
Q304
Open questionIn which of the following machine, the work rotates and the tool is stationary?
Select an option to see the answer and solution.
Q305
Open questionDuring the execution of a CNC part program block NO20 GO2 X45.0 Y25.0 R5.0 ; the type of tool motion will be
Select an option to see the answer and solution.
Q306
Open questionIn order to prevent tool from rubbing the work _________ on tools are provided.
Select an option to see the answer and solution.
Q307
Open questionCarbide tipped tools usually have
Select an option to see the answer and solution.
Q308
Open questionThe advantage of a broaching operation is that
Select an option to see the answer and solution.
Q309
Open questionShrinkage allowance on pattern is provided to compensate for shrinkage when
Select an option to see the answer and solution.
Q310
Open questionHard and tough materials like cast iron should be turned at
Select an option to see the answer and solution.
Q311
Open questionA single point thread cutting tool should ideally have
Select an option to see the answer and solution.
Q312
Open questionDuring normalizing process of steel, the specimen is heated
Select an option to see the answer and solution.
Q313
Open questionA grinding wheel becomes glazed (i.e. cutting edge takes a glass-like appearance) due to
Select an option to see the answer and solution.
Q314
Open questionCalculate the weld per minute, work speed of circular electrode of 220 mm diameter for carrying out seam welding at 4 welds per cm on 1.6 mm thick mild steel tube. Welding cycle consists of 3 cycles ‘on’ and 2 cycles ‘off’ Power supply is at 50 Hz.
Select an option to see the answer and solution.
Q315
Open questionThe helix angle of a drill is __________ for drilling brass.
Select an option to see the answer and solution.
Q316
Open questionThe effect of setting a boring tool above center height leads to
Select an option to see the answer and solution.
Q317
Open questionThe correct sequence of tool materials in increasing order of their ability to retain their hot hardness is
Select an option to see the answer and solution.
Q318
Open questionTool life is generally better when
Select an option to see the answer and solution.
Q319
Open questionHigh speed steel cutting tools operate at cutting speeds _________ than carbon steel tools.
Select an option to see the answer and solution.
Q320
Open questionThe drill spindles are provided with standard taper known as
Select an option to see the answer and solution.