Q321
Open questionThe lathe centres are provided with standard taper known as
Select an option to see the answer and solution.
Mechanical Engineering · all questionsManufacturing And Production Technology
Manufacturing And Production Technology
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
416
Questions
17/21
Page
Pick an option on a question to see the right answer and solution.
Q322
Open questionIn ECM, the material removal is due to
Select an option to see the answer and solution.
Q323
Open questionThe effective number of lattice points in the unit cell of simple cubic, body centered cubic, and face centered cubic space lattices, respectively, are
Select an option to see the answer and solution.
Q324
Open questionIn abrasive jet machining, as the distance between the nozzle tip and the work surface increases, the material removal rate
Select an option to see the answer and solution.
Q325
Open questionTwist drills are made of
Select an option to see the answer and solution.
Q326
Open questionThe cutting speed for drilling aluminium, brass and bronze with high speed steel drills varies from
Select an option to see the answer and solution.
Q327
Open questionThe cutting speed for drilling copper with high speed steel drills varies from
Select an option to see the answer and solution.
Q328
Open questionDiscontinuous chips are formed during machining of
Select an option to see the answer and solution.
Q329
Open questionContinuous chips with built up edge are formed during machining of
Select an option to see the answer and solution.
Q330
Open questionThe operation of producing grooves around the periphery of a cylindrical or conical workpiece is called
Select an option to see the answer and solution.
Q331
Open questionWork speed of circular electrode of 220 mm diameter for carrying out seam welding at 4 welds per cm on 1.6 mm thick mild steel tube. Welding cycle consists of 3 cycles ‘on’ and 2 cycles ‘off’ Power supply is at 50 Hz. Calculate R.P.M. and energy requirement of the above circular electrodes assuming effective resistance between electrodes as 100 ohm.
Select an option to see the answer and solution.
Q332
Open questionInternal gears can be made by
Select an option to see the answer and solution.
Q333
Open questionWhat is the type of welding defect caused due to poor manipulation of weld rod or a dirty joint called?
Select an option to see the answer and solution.
Q334
Open questionThe broaching operation in which the work moves past the stationary tool is called
Select an option to see the answer and solution.
Q335
Open questionThe cutting speed for drilling __________ with high speed steel drills is 24 to 45 m/min.
Select an option to see the answer and solution.
Q336
Open questionTrepanning is an operation of
Select an option to see the answer and solution.
Q337
Open questionLapping is an operation of
Select an option to see the answer and solution.
Q338
Open questionThe saw milling is an operation of
Select an option to see the answer and solution.
Q339
Open questionThe chamfering is an operation of
Select an option to see the answer and solution.
Q340
Open questionThe grooving is an operation of
Select an option to see the answer and solution.