A lap joint is always in _________ shear.
Select an option to see the answer and solution.
Mechanical Engineering · all questionsStrength Of Materials
Strength Of Materials
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
445
Questions
1/23
Page
Pick an option on a question to see the right answer and solution.
A pressure vessel is said to be a thin shell when the ratio of wall thickness of the vessel to its diameter is __________
Select an option to see the answer and solution.
A simply supported beam with a gradually varying load from zero at ‘B’ and ‘w’ per unit length at ‘A’ is shown in the below figure. The shear force at ‘B’ is equal to
Select an option to see the answer and solution.
The columns whose slenderness ratio is less than 80, are known as
Select an option to see the answer and solution.
When a bar of length l, width b and thickness t is subjected to a pull of P, its
Select an option to see the answer and solution.
When a bar of length l, width b and thickness t is subjected to a push of P, its
Select an option to see the answer and solution.
The center to center distance, between two consecutive rivets in a row, is called
Select an option to see the answer and solution.
According to Unwin's formula, the relation between diameter of rivet hole (d) and thickness of plate (t) is given by (where d and t are in mm)
Select an option to see the answer and solution.
When it is indicated that a member is elastic, it means that when force is applied, it will
Select an option to see the answer and solution.
In riveted boiler joints, all stresses, shearing, bearing and tensile are based on the
Select an option to see the answer and solution.
Transverse fillet welds are designed for
Select an option to see the answer and solution.
According to Euler's column theory, the crippling load for a column length hinged at both ends, is
Select an option to see the answer and solution.
The shear force of a cantilever beam of length carrying a uniformly distributed load of w per unit length is _________ at the free end.
Select an option to see the answer and solution.
The bending moment of a cantilever beam of length and carrying a uniformly distributed load of w per unit length is __________ at the free end.
Select an option to see the answer and solution.
If percentage reduction in area of a certain specimen made of material 'A' under tensile test is 60% and the percentage reduction in area of a specimen with same dimensions made of material 'B' is 40%, then
Select an option to see the answer and solution.
The section modulus (Z) of a beam is given by
Select an option to see the answer and solution.
The maximum strain energy that can be stored in a body is known as
Select an option to see the answer and solution.
The extremities of any diameter on Mohr's circle represent
Select an option to see the answer and solution.
A coil is cut into two halves, the stiffness of cut coil will be
Select an option to see the answer and solution.
When a rectangular beam is loaded transversely, the maximum tensile stress is developed on the
Select an option to see the answer and solution.