Compression members always tend to buckle in the direction of the
Select an option to see the answer and solution.
Mechanical Engineering · all questionsStrength Of Materials
Strength Of Materials
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
445
Questions
2/23
Page
Pick an option on a question to see the right answer and solution.
A vertical column has two moments of inertia (i.e. Ixx and Iyy ). The column will tend to buckle in the direction of the
Select an option to see the answer and solution.
The torsional rigidity of a shaft is expressed by the
Select an option to see the answer and solution.
The layer at the center of gravity of the beam as shown in the below figure, will be
Select an option to see the answer and solution.
The lower layer of the beam as shown in the below figure, will be
Select an option to see the answer and solution.
The value of Poisson's ratio for cast iron is
Select an option to see the answer and solution.
The capacity of a strained body for doing work on the removal of the straining force, is called
Select an option to see the answer and solution.
The maximum bending moment for the beam shown in the below figure, lies at a distance of ________ from the end B.
Select an option to see the answer and solution.
Hook's law holds good up to
Select an option to see the answer and solution.
Hooke's law holds good up to
Select an option to see the answer and solution.
A material obeys hook’s law up to
Select an option to see the answer and solution.
A non yielding support implies that the
Select an option to see the answer and solution.
The bending moment diagram for a simply supported beam loaded in its center is
Select an option to see the answer and solution.
The unit of stress in S.I. units is
Select an option to see the answer and solution.
If the section modulus of a beam is increased, the bending stress in the beam will
Select an option to see the answer and solution.
The thermal or temperature stress is a function of
Select an option to see the answer and solution.
The point of contraflexure is a point where
Select an option to see the answer and solution.
The point of contra flexure is a point where
Select an option to see the answer and solution.
Which of the following materials is most elastic?
Select an option to see the answer and solution.
The deformation per unit length is called
Select an option to see the answer and solution.