Q241
Open questionThe deformation of a bar under its own weight compared to the deformation of same body subjected to a direct load equal to weight of the body is
Select an option to see the answer and solution.
Mechanical Engineering · all questionsStrength Of Materials
Strength Of Materials
practice.
Practice every MCQ with options. Use Show answers when you want the correct option and solution.
445
Questions
13/23
Page
Pick an option on a question to see the right answer and solution.
Q242
Open questionFor riveting, the size of hole drilled in plates is __________ shank diameter of rivet.
Select an option to see the answer and solution.
Q243
Open questionA hollow shaft of same cross-section area as compared to a solid shaft transmit
Select an option to see the answer and solution.
Q244
Open questionThe bending moment at a point on a beam is the algebraic ________ of all the moments on either side of the point.
Select an option to see the answer and solution.
Q245
Open questionThe shear force at a point on a beam is the algebraic __________ of all the forces on either side of the point.
Select an option to see the answer and solution.
Q246
Open questionThe value of shear stress which is induced in the shaft due to the applied couple varies
Select an option to see the answer and solution.
Q247
Open questionThe deformation of a bar under its own weight is _________ the deformation, if the same body is subjected to a direct load equal to weight of the body.
Select an option to see the answer and solution.
Q248
Open questionThe stress at which extension of the material takes place more quickly as compared to the increase in load is called
Select an option to see the answer and solution.
Q249
Open questionThe hoop stress in a thin cylindrical shell is
Select an option to see the answer and solution.
Q250
Open questionThe maximum tangential stress in a thick cylindrical shell is always _________ the internal pressure acting on the shell.
Select an option to see the answer and solution.
Q251
Open questionThe maximum stress produced in a bar of tapering section is at
Select an option to see the answer and solution.
Q252
Open questionDiamond riveted joint can be adopted in the case of following type of joint
Select an option to see the answer and solution.
Q253
Open questionIn the below figure, the point E represents.
Select an option to see the answer and solution.
Q254
Open questionIn a riveted joint, when the number of rivets decreases from the inner most row to outer most row, the joint is said to be
Select an option to see the answer and solution.
Q255
Open questionIn a riveted joint, when the rivets in the various rows are opposite to each other, the joint is said to be
Select an option to see the answer and solution.
Q256
Open questionThe ratio of shear modulus to the modulus of elasticity for a Poisson's ratio of 0.4 will be
Select an option to see the answer and solution.
Q257
Open questionThe maximum deflection of a cantilever beam of length '' with a uniformly distributed load of 'w' per unit length is (where W = w)
Select an option to see the answer and solution.
Q258
Open questionThe shear force diagram of a cantilever beam of length ‘l’ and carrying a uniformly distributed load of w per unit length will be
Select an option to see the answer and solution.
Q259
Open questionIf the tearing efficiency of a riveted joint is 50%, then ratio of rivet hole diameter to the pitch of rivets is
Select an option to see the answer and solution.
Q260
Open questionA circular shaft fixed at, A has diameter D for half of its length and diameter D/2 over the other half, as shown in the below figure. If the rotation of B relative to A is 0.1 radian, the rotation of C relative to B will be
Select an option to see the answer and solution.